No, you have to show the whole OSPF database, then look through it with Notepad or something. For example, there's no way to look for a single entry in the OSPF database of a VS other than 0. I would just use clish -c and pipe it through grep and so on, but again, can't get information from VSs other than 0, making it literally unusable for troubleshooting. It's worse since the config line order in clish is not stable between cluster members, so you have to sort the lines to be able to use diff, but you can't just log your SSH session and sort everything, since that loses which VS has each line.Ĭan't use pipes in clish, so it's completely unusable for troubleshooting. This is Check Point's software version R80.40 - Build clish -c "set virtual-system 2 show router-id"ĬLINFR0329 Invalid command:'set virtual-system 2 show clish -c "set virtual-system 2\nshow router-id"ĬLINFR0329 Invalid command:'set virtual-system 2\nshow clish -c "$(echo "set virtual-system 2" echo "show router-id")"ĬLINFR0710 Illegal printf "set virtual-system 2\nshow router-id\n" | chain multiple commands together, which means you can't get any information from VSs other than 0, which means comparing the configuration between VSX cluster members is excruciatingly manual. ![]() And clish -c is completely unusable: fw ver
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |